Fine-tune your paddle’s balance and boost your performance with Bodhi Tungsten Weighted Strips. At 3 grams per strip, these ultra-slim, high-density tungsten weights allow for precise customization without bulk—giving you more power, stability, and control where you need it most.
Whether you’re adding swing weight at the head or increasing the sweet spot at the sides, these strips are the go-to solution for serious players looking to level up.
✅ 3g per strip for easy, precise tuning
✅ Slim, low-profile design
✅ Peel-and-stick adhesive backing
✅ Optimized for competitive edge and personalized feel
Your paddle. Your specs. Your advantage.
Specifications:
Weight: 3G per strip
Length: 5 CM/1.96 INCHES
Width: 1 CM/0.4 INCHES
Height(Thickness): ~1mm (It's thin)
1 / 1
Press & drag to view
How to Install an Overgrip
HOW TO
Step1
Remove Plastic Film (PROtack Only)
NOTE: There are TWO sides to the grip. Remove the plastic film from both sides.
Step2
Find Tapered Side
Remove the paper from the adhesive side of the grip. This is the side that you will start with.
Step3
Start From End Cap
Hold your paddle upside down. Apply the adhesive side of the overgrip to the edge of your end cap, on top of your stock grip. Begin wrapping your handle. Overlap the overgrip to your preferred thickness. If you are a lefty, wrap to the left. If you are a righty, wrap to your right.
Step4
Apply End Tape
Once you have wrapped your handle to the desired length, cut off excess overgrip (if any), and apply the end tape to hold the grip.
